![]() ![]() ![]() The iOne Display probe will be better than a monki for display calibration, but everything else I mentioned still applies. The editor hasn't finished working on the film yet, so maybe I have a little bit of time to study beforehand. I'll definitely take a look at Displa圜al. #Displaycal resolve pro#I do have access to an i1 Display Pro at work that I might be able to calibrate my home monitor with while working on this project, but unfortunately, in this case, I am on a PC. ![]() icc profile aware, which muddies things a bit. So, if you are up for an adventure in display calibration and learning color correction in Resolve, this can be an opportunity, but don't try this on a deadline!įor further help and information, visit the Displa圜al forums and forums. The are documents on the Displa圜al site to describe the process, but you may well find them difficult to follow as they are not perfectly clear for newbies. But here, you will have a bit of a learning curve, both for Resolve perhaps, and Displa圜al. #Displaycal resolve software#The best solution would be to use Displa圜al, open source software to create a 3D display LUT that you will load into Resolve for grading. icc profile aware software, so if you are using a PC, you won't get a display calibration that can be used with Resolve. If you want to try, 1st set your display via the display's own controls to "sRGB" or "REC709" if that's offered. I'm not sure you can calibrate your display to REC709 using a color munki and it's software. You don't need a 4k display to grade a 4k project.īut you do need a calibrated REC709 display. I have graded C100, FS5ii, GH4, and even downscaled RED footage on this monitor with good results, but because she specifically asked if my monitor is 4K, I'm beginning to wonder if maybe my monitor wouldn't be accurate enough for her project.Īs far as I know, the only problems I would have are judging sharpness and noise, but as far as color goes it should be fairly accurate regardless of my monitor's resolution as long as I calibrate properly, right? Or is there something I'm missing here? I'd love to help with her project, but I also don't want to waste her time. What I do have is an IPS 1920x1200 monitor, specifically a ProArt ASUS PA248Q, and a ColorMunki. Then she told me that the footage was V-Log 4K shot on the Panasonic EVA1 and asked if I have a 4K monitor, which I don't. I happen to do a lot of color correction for my job as well as just for fun when I want to mess around in Resolve, so I was confident that I could do what the director was asking for (she said she wants it to look true to life, so mostly just primary corrections it sounds like). This might be a question that exposes my ignorance, but recently I was asked if I could grade a 30 minute documentary for someone. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |